Simulation and collision detection of 3, 4 5-axis simultaneous machining.
This improves the alphacam quality of the part and reduces programming time.
New and improved solid simulator that allows for any machine configuration to be alphacam built from 3D solids and/or extruded 2D geometries.Nesting Zones Small parts can now be identified and nested into specific areas of a sheet.An overview of the key features within this release including: Spot Drill and Chamfering, Tool Path Oscillation, Automatic Part Tagging, Nesting Zones, Part Panelling and new spcrack powerful Combined Pocketing and Finishing Pocket cycle.All selected holes, including spcrack Auto Z support, will be analyzed to ensure the tool can enter the hole where there is spcrack a flat spcrack on the bottom alphacam of the tool, and that the tool diameter is sufficient to complete the full depth of chamfer.
This allows for large geometries to be broken into sectioned pieces and automatically serial placed within separate panels intuit (sheets).
The All cycles can now be output as Local Linear manual as well gtui as the existing Global Linear.
Enhancements to the Wave Add-In, used for the machining of decorative wave panelling.This resource contributes to reducing material wastage and improving the quality of the part.This button is also available in the Model application.Geometry Paneling A new Paneling command allows for large geometries to be broken into sectioned pieces and automatically placed within separate panels (sheets).Small parts can now be identified and nested into specific areas of a sheet.Area clearance and finish contour machining can now be combined into a single machining operation.Automatically patch explodes complex BTL format assemblies into Alphacam components ready for machining using "Layered Machining Styles".Automatic Support Tags Support tags can be added automatically to any contour tool path (including 5-axis allowing the part to stay attached to the material being machined.The introduction of the "Construction" line button, found on the "Locate" Toolbar.Allows faces that manual are partially within the window selection to be selected (Right to Left window selection).
Various enhancements have been made to the Drawing Application within Part Modeler.
A sinusoidal or zig-zag up and down movement can be applied to any contour tool path, utilizing more of the effective alphacam 2013 r1 sp2crack - jo3k cutting length of the tool used.